LCD alarm remote motorcycle alarm system with remote anti hijacking feature big sound siren alarm
Model No: MT170A
Brand:cardot

Two Way Motorcycle Alarm
 
Main Functions:
 

1. sound arm or disarm

2. shock sensor alarm

3. illegal ignition start alarm
4. alarm pause
In alarming status,press the button lock to pause alarming.The system will arm again.And both of transmitter will stop alarming.
 
5. Reminding motorcycle owner of arming
Park the motorcycle and ACC OFF,if the system is not armed within 8 seconds,the system will beep 3 times with gleaming of flash lights to remind to arm the motorcycle.
 
6. Anti-robbery mode

7.  Remote start engine with long distance
press remote start button 2 times within 3 seconds

8. Remote Stop Engine with long distance
press remote lock button 1 time to stop engine
 
9. Automatical rearm motorcylce system
if forget to arm motorcycle,system will be auto arming after almost 25seconds
 
10. Motorcycle searching

press remote finding button to locate motorcyle
 
11. Power off memory
In case the power supply is cut off,the system will restore to previous status.
 
12. Day&Night monitoring
In disarm status,if ACC ON,the remote control wil beep with vibration to remind the owner to arm the system.
 
13. Emergency reset original status

emergency disarm by ACC
 
14. Signal indicator
 
15. green back light

16.  Remote Power status indication

17. Time Alarm setting Mode

18. Shock Sensitivity Adjusting

19. Built in learning code switch 

20. AC engine off mode

Product Standard Compositions:
 
1 control unit,2pcs alarm lcd remotes,1pc alarm siren,1pc main cables,1pc english manual,1pc color box.

Motorcycle Alarm Installation Instruction:

Disconnect the motorcycle's battery before you begin the installation.

1. Connect the + (positive) side of the motorcycle battery to the red wire of the alarm.

2. Connect the black wire from the alarm to a good earth on the motorcycle frame.

3. Identify the wire color for the indicators. Then splice mean = to join with] each of the yellow wires of the alarm one to the

left indicator circuit and then the other to the right indicator circuit.

4. Identify an appropriate switched (on only when the ignition is on) source, and splice to the orange wire of the alarm.

5. Identify the supply from the motorcycle ignition switch that supplies the ignition system – the coil and ECU. Please make sure

you take this feed before any ignition relay. Cut this wire and attach the side from the motorcycle ignition switch to the pink wire and attach the side that goes to activating the ignition system to the gray wire.

6. Identify the wire from the starter switch to the starter relay. Splice in the blue wire from the alarm.

    On completion of the fitting of the alarm, reconnect the motorcycle battery and check the alarm functions correctly by testing the operations as described in the “alarm operation” manual. If the alarm does not function correctly, please check all your connections carefully. A multimeter can be of use to ensure that you have correctly identified the motorcycle wires.

Product Real Photos:
 
 

Real Photos: